8-35V 3A 1ch Buck converter - BD9874CP-V5The BD9873CP-V5 and BD9874CP-V5 single-channel step-down switching regulator incorporates a Pch MOSFET capable, as well as circuitry that eliminates the need for external compensation – only a diode, coil, and ceramic capacitor are required – reducing board size significantly.
| ||||
| * This product is a STANDARD grade product and not recommend for on-vehicle devices. | ||||
| Grade | Standard |
| ch | 1 |
| Integrated FET / Controller | Integrated FET |
| Buck / Boost / Buck-Boost / Inverting | Buck |
| Synchronous / Nonsynchronous | Nonsynchronous |
| Vin1(Min.)[V] | 8.0 |
| Vin1(Max.)[V] | 35.0 |
| Vout1(Min.)[V] | 1.0 |
| Vout1(Max.)[V] | 28.0 |
| Iout1(Max.)[A] | 3.0 |
| SW frequency(Max.)[MHz] | 0.11 |
| Light Load mode | No |
| EN | Yes |
| PGOOD | No |
| Operating Temperature (Min.)[°C] | -40 |
| Operating Temperature (Max.)[°C] | 85 |
- ・Maximum switching current : 1.5A, 3.0A
・Built-in Pch FET ensures high efficiency
・Output voltage adjustable via external resistors
・High switching frequency : 110kHz (fixed)
・Soft start time : 4ms (fixed)
・Over current and thermal shutdown protection circuits built in
・ON/OFF control via STBY pin
 |
| PART NUMBER | Product Name | Package | Datasheet | Distribution Inventory |
|---|---|---|---|---|
| BD9873CP-V5 | 8-35V 1.5A 1ch Buck converter | TO220CP-V5 | Buy Sample |
The definition and how to use thermal resistance and thermal characterization parameter of packages for ROHM’s integrated circuit are described in this application note.
This application note describes how to obtain the power loss required to calculate the temperature of a semiconductor device. Temperature control is important to ensuring product reliability.
The definition and how to use thermal resistance and thermal characterization parameter of packages for ROHM’s integrated circuit are described in this application note.
This application note introduces a method for easily measuring the phase margin with a Frequency Response Analyzer (FRA) made by NF Corporation.
This Application Note offers reference table to easily set resistor values for output voltage with various internal reference voltages VREF.
Major problems that arise from in appropriate layout may cause increase in noise superposed by output and switching signal, the deterioration of regulator, and also lack of stability...
In buck converter ICs, many high-frequency noises are generated at switch nodes. A snubber circuit provides one way of eliminating such harmonic noise. This application note explains how to set up the RC snubber circuits.
This application note explains the calculation of external capacitor value for buck converter IC circuit.
This application note covers the steps required in choosing the inductor and to calculate the value used in buck regulator IC circuits.
This application note explains power loss factors and methods for calculating them. It also explains how the relative importance of power loss factors depends on the specifications of the switching power source.
Using unmatched MLCC may not obtain required target characteristics for power supply circuit and may cause abnormal operation. This application note explains the important points while using MLCC.
This application note explains the features and things to consider when shopping for power inductors.
For ICs